I setup it while referring to your doc file as follows.
But it was lighted 'Red lamp' in ONLINEKISS. See an attached jpg file.
------------------------------------------------------------------------
(1)Start - Control Panel - System - Hardware - Device Manager
- Multi Port Serial Adapter - MixW serial port bridge
- Properties - Pair#1:
First emulated port: COM7 for input
Second emulated port: COM8 for output
and
Pair#2:
First emulated port: COM10 for input
Second emulated port: COM11 for output
(2)MixW: Configure - TNC emulation port - Serial port - COM10 for output
(3)ONLINEKISS: File - TNC Setup - COM11 for incoming data
COM7 for outgoing data
ONLINEKISS: Options - mirror incoming data from COMM A to COMM B
(4)CPXDD: File - Preferences - TNC - Port: COM8 for input
------------------------------------------------------------------------
When I read the figure of the beginning of the doc file,
I think that (5)MixW serial port bridge
- Pair#1:
First emulated port: COM10 for input
Second emulated port: COM11 for output
and
Pair#2:
First emulated port: COM7 for input
Second emulated port: COM8 for output
Which of (1) and (5) is right?