SDR# setup on Windows102018年06月09日 17時15分

SDR# を Windows10上で起動する方法
英訳 by JE9PEL

Download and install SDR# of 32bit or 64bit version to Windows10 from SDRSharp HP.
In case of 32bit virsion SDR#, copy to SDR#_folder the three files: "rtlsdr.dll, NDde.dll,
and SDRSharp.DDETracker.dll". And edit as follows "SDRSharp.exe.Config" and "Plugins.xml".
Refer My HP, SDR# Setup.

  <add key="RTL-SDR / USB" value="SDRSharp.RTLSDR.RtlSdrIO,SDRSharp.RTLSDR" />

  <add key="DDE Tracking Client" value="SDRSharp.DDETracker.DdeTrackingPlugin,SDRSharp.DDETracker" />

In case of 64bit version of SDR#, it displays an error message as "No device selected"
in "Device" of "RTL-SDR Controller". The reason for this is that rtlsdr.dll is old and
SDR# can not deal with it. Then do 1, 2, 3 below. Currently, only 32bit version is on HP
of SDR#, there is no need to consider 1,2,3 below. Since 32bit version of SDR# works on
any Windows PC of 32bit or 64bit, It is enough to consider the steps after 4 below.

 1. Download RTLSDR Driver directly from:

 2. When you unzip it, "RelWithDebInfo" folder is automatically generated.
    There is an "rtl-sdr-release" folder in it, and there are also two folders x32 and x64.

 3. When copying "rtlsdr.dll" in x64 folder to the same folder as SDRSharp,
    "RTL 2832U" is displayed in the Device column of "RTL-SDR Controller" and
    SDR# runs on Windows10(64bit).

 4. Set SDR# as follows.

 5. Create the shortcut for SDRSharp.exe on your desktop.

 6. At first, SDR#_icon on desktop -> Right click -> Properties -> Compatibility
     -> Check "Activate this program as administrator".

 7. Secondly, double-click this SDR#_icon on desktop and SDR# will start correctly on Windows10.

 8. On Windows10, you may need to check the full control of "Access permission"
    on "SDR# folder -> Right click -> Property -> Security -> Users".

 9. SDR# upper left -> select "Source RTL(USB)" and set other items according to the procedure.

10. SDR# -> click the gear button -> RTL-SDR Controller
      -> Confirm that "RTL2832U" etc. is displayed in the Device column.
      -> In "Sample rate", it may be necessary to lower the default value.
      -> "Frequency correction(ppm)" has to be adjusted by trial and error.

DTUsat-2 weak 2.4GHz CW2018年06月09日 18時04分


1KUNS-PF 画像データ描画法2018年06月09日 23時49分

1KUNS-PF 画像描画 by JA0CAW

1KUNS-PF 描画再生 by JE9PEL